HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 159

4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the secondary riser cage.
9. Disconnect the boot device signal and power cables from the system board .
10. Remove the boot device cage assembly:
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this task About this task
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with CAUTION:
either a component or a blank.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. If installed, open the cable management arm .
boot device carrier without the security cover installed carrier without the security cover installed
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 159