HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 107

b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Remove the OCP NIC 3.0 adapter.
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Pull the OCP 3.0 NIC adapter out of the bay (callout 2).
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card Removing and replacing an expansion card
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a CAUTION:
riser slot blank or an expansion card installed.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 107