Table of Contents
Advertisement
WARNING:
WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack has anti-tip measures in place. Such measures include floor-bolting, anti-tip feet, ballast, or a combination as
specified by the rack manufacturer and applicable codes.
The leveling jacks (feet) are extended to the floor.
The full weight of the rack rests on the leveling jacks (feet).
The stabilizing feet are attached to the rack if it is a single-rack installation.
The racks are coupled together in multiple rack installations.
WARNING:
WARNING:
To reduce the risk of personal injury or equipment damage when unloading a rack:
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack can weigh as much as 115
kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might become unstable when being moved on its casters.
Never stand in front of the rack when it is rolling down the ramp from the pallet. Always handle the rack from both
sides.
CAUTION:
CAUTION:
Always plan the rack installation so that the heaviest item is on the bottom of the rack. Install the heaviest item first, and
continue to populate the rack from the bottom to the top.
CAUTION:
CAUTION:
Before installing the server in a rack, be sure to properly scope the limitations of the rack. Before proceeding with the
installation, consider the following:
You must fully understand the static and dynamic load carrying capacity of the rack and be sure that it can
accommodate the weight of the server.
Be sure sufficient clearance exists for cabling, installation and removal of the server, and movement of the rack doors.
Server warnings and cautions
Server warnings and cautions
WARNING:
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, disconnect the power cord to remove
power from the server. Pressing the Power On/Standby button does not shut off system power completely. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
WARNING:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
WARNING:
WARNING:
To reduce the risk of fire or burns after removing the energy pack:
Do not disassemble, crush, or puncture the energy pack.
Do not short external contacts.
Do not dispose of the energy pack in fire or water.
Do not expose the energy pack to low air pressure as it might lead to explosion or leakage of flammable liquid or gas.
Do not expose the energy pack to temperatures higher than 60°C (140°F).
After power is disconnected, battery voltage might still be present for 1s to 160s.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide
43
Advertisement
Table of Contents
