HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 102

14. Remove the GPU riser board (callout 1) and disconnect the power cable (callout 2).
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing an OCP slot blank Removing and replacing an OCP slot blank
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Spudger or any small prying tool
About this task About this task
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 102