HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 97

To replace the component, reverse the removal procedure.
Removing and replacing the riser cage Removing and replacing the riser cage
About this task About this task
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
9. To remove the rear riser cage, do the following:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 97