System Board Assembly Replacement; Removing The System Board Assembly - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

System board assembly replacement

System board assembly replacement
Subtopics Subtopics

Removing the system board assembly

Removing the system board assembly
Installing the system board assembly Installing the system board assembly
Re-entering the server serial number and product ID Re-entering the server serial number and product ID
Removing the system board assembly Removing the system board assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
T-30 Torx screwdriver
Hex screwdriver—This tool is required if the serial port cable is installed.
Alcohol wipe
System board handle (ships with the system board spare)
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the middle cover .
9. Disconnect all cables and remove all components from the system board assembly:
M.2 air baffle
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 169