HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 111

3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 air baffle .
9. Remove the fans.
10. Remove the fan board.
Retain the screws for further use.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a serial port Removing and replacing a serial port
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
About this task About this task
Procedure Procedure
1. Power down the server.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 111