Removing And Replacing The Chassis Intrusion Detection Switch - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

Removing and replacing the chassis intrusion detection switch

Removing and replacing the chassis intrusion detection switch
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the chassis intrusion detection switch:
a. Disconnect the switch cable and release it from the cable clamp (callout 1).
b. While carefully retracting the snap-in latch (callout 2), pull out the tab from the chassis slot (callout 3).
Results Results
To replace the component, reverse the removal procedure.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 168