Processor Replacement; Processor Cautions; Removing The Processor - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

Processor replacement

Processor replacement
Subtopics Subtopics

Processor cautions

Processor cautions

Removing the processor

Removing the processor
Installing the processor Installing the processor
Processor cautions Processor cautions
CAUTION: CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
CAUTION: CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must
contain processors with the same part number.
CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged . To avoid component
damage, do not touch these pins do not touch these pins. Any damage to them might require replacing the system board and/or processor.
IMPORTANT: IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
IMPORTANT: IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To
download firmware, see Updating firmware or system ROM .
Removing the processor Removing the processor
Prerequisites Prerequisites
Identify the heatsink and processor socket components .
Review the processor cautions .
Before you perform this procedure, make sure that you have the following items available:
T-30 Torx screwdriver
Alcohol wipe
About this task About this task
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 140