HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 88

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a DIMM blank Removing and replacing a DIMM blank
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Remove the DIMM blank.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 88