HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 165

Retain the SSD and mounting screw for installation onto the new boot device carrier.
14. If you are removing the second boot device carrier, repeat steps 3 and 4 on the lower boot device carrier slot.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Phillips No. 1 screwdriver
T-10 Torx screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
boot device drive with the security cover installed drive with the security cover installed
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 165