Rear Panel Leds - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

Item Item Description Description
1 Slot 1 PCIe5 x16 (16, 8, 4, 2 (Gen4))
2 Slot 2 PCIe5 x16 (16, 8, 4, 2 (Gen4))
3 Power supply 2 (PS2)
4 Power supply 1 (PS1)
5 Slot 14 OCP PCIe5 x16
6 Video (VGA) port
7 USB 3.2 Gen1 ports
8 iLO Management Port
9 Embedded 1x2 network port
10 Serial port (optional)
Subtopics Subtopics
Display device setup Display device setup
Display device setup Display device setup
This server supports both VGA port and Display port 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible PCIe5 graphics card that supports this feature in the expansion slot.

Rear panel LEDs

Rear panel LEDs
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 191