Table of Contents
Advertisement
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Allow all internal system components to cool before continuing.
9.
CAUTION:
CAUTION:
Heatsink screws must be tightened and loosened in alternating sequence. Do not overtighten the screws as this might
damage the system board or the processor socket.
Use a T-30 Torx screwdriver to loosen one pair of diagonally opposite screws (callouts 1 and 2), and then loosen the other pair of screws
(callouts 3 and 4).
Standard heatsink
Performance heatsink
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide
141
Advertisement
Table of Contents
