HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 90

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the left chassis ear Removing and replacing the left chassis ear
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the left chassis ear:
a. Remove left chassis ear screws (callouts 1 and 2).
Retain the screws. These screws will be used to secure the new left chassis ear spare.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 90