Removing And Replacing An Energy Pack - HPE ProLiant DL320 Gen11 Maintenance And Service Manual

CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the server
when a port blank is removed without the corresponding I/O port option installed.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the OCP slot blank:
a. Remove the blank screw (callout 1).
b. Remove the blank (callout 2).
Retain the screw and blank for future use.
Results Results
To replace the component, reverse the removal procedure.

Removing and replacing an energy pack

Removing and replacing an energy pack
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 103