HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 95

Removing and replacing an accelerator from the GPU riser cage Removing and replacing an accelerator from the GPU riser cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to WARNING:
cool before touching them.
CAUTION: CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation
procedure. Improper grounding can cause electrostatic discharge.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Remove the middle cover .
10. Remove the GPU riser cage.
11. Remove the GPU bracket retainer (callouts 1 and 2) and the accelerator (callout 3).
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing an accelerator from the rear riser cage Removing and replacing an accelerator from the rear riser cage
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 95