HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 84

c. Repeat steps a and b to remove the other rack rail.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the middle cover Removing and replacing the middle cover
About this task About this task
This middle cover is used in the LFF drive chassis.
CAUTION: CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks
installed.
CAUTION: CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
Procedure Procedure
1. Power down the server.
2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 84