HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 73

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the universal media bay blank Removing and replacing the universal media bay blank
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with CAUTION:
either a component or a blank.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 73