HPE ProLiant DL320 Gen11 Maintenance And Service Manual page 161

5. If you are removing the second boot device carrier, repeat steps 3 and 4 on the lower boot device carrier slot.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this task About this task
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with CAUTION:
either a component or a blank.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. If installed, open the cable management arm .
3. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
boot device drive without the security cover installed drive without the security cover installed
HPE ProLiant DL320 Gen11 Server Maintenance and Service Guide 161