Table of Contents
Advertisement
7800/7700 MultiFrame Manual
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
6.2.1.10. Force Freeze Frame
This control enables or disables Force Freeze Frame. It is a manual user control to freeze the output of
the card. When set to off, the module will run as expected. When enabled, the output picture will freeze
with the last frame of video.
6.2.1.11. Loss of Video Mode
This control defines the action that will be taken when the input video is lost. You can choose to freeze the
output video on the last good frame of input video, force the output video to black or force the output video
to blue. The Loss of Video Mode drop down menu appears as follows:
6.2.1.12. User Added Video Delay
This slider control is used to add additional user delay to the video. Up to an additional 17 frames of delay
can be added.
6.2.2. Video Output Control
The 7812UDXD has a dual output architecture that enables two simultaneous output standards sourced
by one input. For the sake of brevity, only the controls for Video output Control 1 will be described as
the controls for Video Output Control 2 operate in the same fashion.
6.2.2.1.
Output Video Standard
The Output Video Standard control selects the output standard desired. Note that only conversions
within the same frame rate family are supported. The module is not capable of converting between
59.94/60 Hz and 50 Hz related frame rates (i.e. standards conversion is not possible). The drop down
menu for Output Video Standard appears as follows:
(Output 1 Video Standards)
(Output 2 Video Standards)
Page - 31
Revision 1.1.1
Advertisement
Table of Contents
