Configuring The Video Controls; Set The Video Input Source (7710Arc Version Only); Set The Video Input Standard; Table 7-2: Video Controls - evertz 7710ARC Series Manual

7.3.

CONFIGURING THE VIDEO CONTROLS

The Video menus are used to configure parameters associated with the input and output video standards
and handling. Table 7-2 shows the items available in the Video menu. Sections 7.3.1 to 7.3.9 provide
detailed information about each of the menu items.
Video Source
Video Input
Loss of Video
Reference Select
External Genlock
H Phase offset
V Phase offset
Ancillary Data
AP Blanking Bypass
Line

7.3.1. Set The Video Input Source (7710ARC version only)

Video
Video source
PGM In
PGM Backup

7.3.2. Set The Video Input Standard

Video
Video input
auto
525i/59.94
625i/50
Selects which input is to be used (7710ARC only)
Set the input video standard
Selects the action to take when program video input is missing
Selects the source of the program video output reference
Selects the source of external Genlock
Selects the horizontal phase offset
Selects the vertical phase offset
Select if ancillary data (non-video) is passed to the output
Bypass selected lines of input image before sending it to the image
conversion process – bypass captions and other data to output

Table 7-2: Video Controls

This control is used to select the video input source. This control is
only available on the 7710ARC module.
When set to PGM IN, the video input source will be supplied by the
program input BNC.
When set to PGM Backup, the video input source will be supplied by
the program backup BNC.
This control is used to set the input video standard.
When set to auto, the module will auto detect the standard.
When set to 525i/59.94, the module will be set to accept only
525i/59.94 video signals.
When set to 625i/50, the module will be set to accept only 625i/50
video signals.
Revision 1.1
7700 MultiFrame Manual
7710ARC Series - SD Aspect Ratio Converter
7710ARC-19