Setting The Fine Phase Of The Output Video - Ntsc/525 Video; Setting The Fine Phase Of The Output Video - Pal-B/625 Video; Setting The Horizontal Phase Of The Output Video - Ntsc/525 Video; Setting The Horizontal Phase Of The Output Video - Pal-B/625 Video - evertz 7735CEM Manual

7700 MultiFrame Manual
7735CEM Composite Encoder with Monitoring
7.5.6. Setting the Fine Phase of the Output Video – NTSC/525 Video
Video/SID
525 fine phase
-128 to 127
0
7.5.7. Setting the Fine Phase of the Output Video – PAL-B/625 Video
Video/SID
625 fine phase
-128 to 127
0
7.5.8. Setting the Horizontal Phase of the Output Video – NTSC/525 Video
Video/SID
525 H phase
0 to 1715
0
7.5.9. Setting the Horizontal Phase of the Output Video – PAL-B/625 Video
Video/SID
625 H phase
0 to 1727
0
7735CEM-22
Gray background indicate un-implemented or un-tested features
With this control, you can set the horizontal fine phase timing of the output
video with respect to the Genlock when operating in NTSC/525 video mode and
locking to the reference input (this control is not available when locking to the
input video). Increasing the value will delay the output video. There is
approximately 250 ns range on this control.
Warning: For a set output horizontal phase, there are a few fine phase/H phase
combinations that will achieve the same position. For best results, set this
control to 0, set the H phase to get within 37ns of the desired position, then
adjust this control to get closer.
With this control, you can set the horizontal fine phase timing of the output
video with respect to the Genlock when operating in PAL/625 video mode and
locking to the reference input (this control is not available when locking to the
input video). Increasing the value will delay the output video. There is
approximately 250 ns range on this control.
Warning: For a set output horizontal phase, there are a few fine phase/H phase
combinations that will achieve the same position. For best results, set this
control to 0, set the H phase to get within 37ns of the desired position, then
adjust this control to get closer.
With this control, you can set the horizontal timing of the output video with
respect to the Genlock reference input when operating in NTSC/525 video
mode. Increasing the value will delay the output video in one-sample
increments.
Warning: For a set output horizontal phase, there are a few fine phase/H phase
combinations that will achieve the same position. For best results, set the fine
phase control to 0, set this control to get within 37ns of the desired position,
then adjust the fine phase control to get closer.
With this control, you can set the horizontal timing of the output video with
respect to the Genlock reference input when operating in PAL/625 video mode.
Increasing the value will delay the output video in one-sample increments.
Warning: For a set output horizontal phase, there are a few fine phase/H phase
combinations that will achieve the same position. For best results, set the fine
phase control to 0, set this control to get within 37ns of the desired position,
then adjust the fine phase control to get closer.
Revision 1.1.1