Video Connections; Generator Sync Lock; Character Inserter Video; Vitc Generator Video In/Out - evertz 5010 SIE Instruction Manual

!
2.4.

VIDEO CONNECTIONS

!
INSTALLATION
Never replace with a fuse of greater value.
Make sure that the arrow is pointing down when you replace the fuse
holder. Close the door on the power entry module and connect the mains
voltage.

2.4.1. Generator Sync Lock

For proper frame/address synchronization in video tape applications, the
generator must be locked to a stable 1 volt p-p composite video or colour
black source, applied to the generator REF VIDEO IN video loop. The
internal sync separator has a high impedance input tapped off the loop
through, therefore, the video signal must be properly terminated at the end
of the line.

2.4.2. Character Inserter Video

The input video on which the characters are to be displayed is connected
to the VIDEO CHAR GEN INPUT connector.
internal 75 ohm termination.
The program video with characters inserted is available on the VIDEO
CHAR GEN OUTPUT connector and may be used to drive a preview
monitor or a video recorder.
connected to the VIDEO CHAR GEN INPUT connector. Size, position, and
style of the character displays are controlled from the on screen
programming menu.
In order to use the on screen programming menu system, video must be
applied to the VIDEO CHAR GEN INPUT connector and the VIDEO CHAR
GEN OUTPUT must be connected to a video monitor.

2.4.3. VITC Generator Video In/Out

The program video source for the VITC generator is applied to the PGM
Video Input loop. The internal sync separator has a high impedance input
tapped off the loop through, therefore, the video signal must be properly
terminated at the end of the line. Program video with VITC is available on
two separate video outputs.
Model 5010-SIE Source ID Encoder Manual
Characters are keyed into the video
The video input has an
Page 2-4