How To Set The Generator User Bits - evertz 4025 Instruction Manual

OPERATION
entry mode is active, and the dual functioned keys are now changed to
their numeric values. If you want to re-enter this time press the ENTER
key to complete the data entry into the generator time.
Pressing any numeric key will clear the previous value and place the new
value into the numeric display, starting at the right. Unentered digits are
assumed to be zero, hence leading zero digits are not required. When the
required number of digits are entered, then press the ENTER key to
complete the data entry into the generator time.
Attempts to enter too many digits, or make illegal entries, i.e. 65 minutes,
will result in the display returning to the last valid time entry made.
Re-enter the correct value and press the ENTER key. Pressing the CLR
key will cancel the data entry mode without changing any data.
The numeric keys return to their normal display functions when the data
entry has been completed by pressing ENTER or cancelled by pressing the
CLR key. The display prompt will return to its steady on state when data
entry mode has been completed.
Numeric entry mode must be terminated (the display prompt will be on
steady) before any of the front panel keys will resume normal operation.
In the RUN modes, press GEN RUN / HOLD to start or stop the generator
clock. In the CINE modes, the generator will start and stop with the
telecine film motion.

3.9.4 How to Set the Generator User Bits

When entering user bits data make sure that the generator is programmed
for NUM user bits mode. If it is in one of the EDGE OR RDR2 modes, use
the format menu as described in section 3.2 to select the NUM user bit
mode. Press the L-GEN or V-GEN keys to display the LTC or VITC
generator respectively. (Currently the LTC and VITC generators are the
same.) Press the TIME / UB key to display the generator user bits if they
are not already displayed. The colons of the display are blanked when
user bits are displayed.
conjunction with the numeric keys to set the generator user bits.
Press the ENTER key to recall the last User Bits that you entered into the
generator. The display prompt at the left of the display will blink while data
entry mode is active, and the dual functioned keys are now changed to
their numeric values. If you want to re-enter these User Bits press the
ENTER key to complete the data entry into the generator.
Pressing any numeric key will clear the previous value and place the new
value into the numeric display, starting at the right. Pressing the SHIFT
key and the numeric keys 0 to 5 will enter the corresponding hexadecimal
values A to F.
Model 4025 Film Footage Encoder Manual
The ENTER and CLR keys are used in
Unentered digits are assumed to be zero. When the
Page 41