Table of Contents
Advertisement
RIGOL
SourceA and SourceB are CH1-CH4 and Ref1-Ref10.
Note:
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source
of Math3 can be CH1-CH4, Ref1-Ref10, Math1, or Math2; the source of
Math4 can be CH1-CH4, Ref1-Ref10, Math1, Math2, or Math3; only the
channels that have been enabled currently can be selected.
Press Offset to set the vertical offset of the operation results. For setting
⚫
methods, refer to the descriptions in "Parameter Setting Method". You can
also directly rotate Wave Vertical
to adjust the vertical offset.
Press Scale to set the vertical scale of the operation results. For setting methods,
⚫
refer to the descriptions in "Parameter Setting Method". You can also
directly rotate Wave Vertical
the vertical scale.
Press More → AutoSetting to adjust the vertical scale and offset of the
⚫
operation results to the optimal value according to the current configuration, so
as to better observe.
Press More → Invert to enable or disable the inverted display function of the
⚫
waveform.
Press More → Expand to expand or compress the math operation waveform
⚫
around the "Center" or "GND".
Press More → Label to set the label for math operation results. For details,
⚫
refer to descriptions in "Math Operation Label".
Press More → Color Grade to enable or disable the color grade display of the
⚫
operation results. When enabled, different colors are displayed on the screen to
indicate the times of data acquisition or acquisition probability.
Press More → Reset ColorGrade to clear the color grade display and display
⚫
the color grade again.
Multiplication
Multiplies the waveform voltage values of signal source A and B point by point and
displays the results.
Press Math → Math1 → Operator to select "A× B":
Press Operation continuously to enable or disable the multiplication operation
⚫
function.
Press SourceA and SourceB respectively, and rotate the multifunction knob
⚫
to select the channel for SourceA and Source B. Then press down the knob
to select the channel. You can also press SourceA and SourceB continuously
or enable the touch screen to select the channel. The available channels for
SourceA and SourceB are CH1-CH4 and Ref1-Ref10.
Note:
The source of Math2 can be CH1-CH4, Ref1-Ref10, or Math1; the source
6-4
Chapter 6 Operations and Measurements
POSITION or enable the touch screen
SCALE or enable the touch screen to adjust
MSO8000 User Guide
Advertisement
Table of Contents
