Connection Of The Fieldbus Interface - WAGO CANopen 752 Manual

4.2.6 Connection of the Fieldbus Interface

The WAGO-I/O-SYSTEM 752 for CANopen provides two base modules.
4.2.6.1 Fieldbus Connection 9 pole D-SUB female connector
The fieldbus connection with the 9-pole connector is on the base module with
the item number 752-828.
9 pole D-Sub female connector
Fig. 4-14: Connection design D-SUB
4.2.6.2 Fieldbus Connection 5 pole male connector
The fieldbus connection with the 5-pole connector is on the base module with
the item number 752-827.
5-pol. male connector
Fig. 4-15: Connection design MULTISTECKERSYSTEM
The Open-Style Connector 231-305/010-000/050-000 from the WAGO
MULTI CONNECTION SYSTEM is included. The Connector has gold plated
contacts and printed signal marking at the cantact location.
For the connection of smaller cross-sections an insulation stop of series 231-
670 (white 0.08 - 0.2mm), 231-671 (light gray 0.25 - 0,5mm) or 231-672 (dark
gray 0.75 -1mm) should be used. The marking of the connectors can be made
with 210-312. Additionally, housing parts, test plugs with cable and male con-
nectors for cable extensions are available from the MCS series (pin spacing
5.08 mm / 0.200 in). Please contact your local WAGO office or distributor for
further information on the MCS series.
Fieldbus Dependent I/O Module
CANopen
(CAN_V+)
9
8
CAN_H
7
6
(CAN_V+)
CAN_H
Shield
CAN_L
GND
5 Shield
4
3 GND
2 CAN_L
1
Installation • 21
g1xx800e
g1xx700e