Table of Contents
Advertisement
8.1.4
Specifications of the I/O Modules
This section describes the specifications of Low Voltage Directive compliant I/O Mod-
ules.
1) 100- to120-VAC 16-point Input Modules
Table 8.2 Specifications of 100- to120-VAC 16-point Input Modules
Item
Name
Model Name
Model No.
Rated Voltage
Maximum Allowable Voltage
Rated Frequency
Allowable Frequency Range
Inrush Current
Rated Current
Input Impedance
Standard Operating Ranges
Input Type
Input Delay Times
Number of Commons
Number of Inputs per Common
Input Power Supply per Common
External Connections
Number of Inputs
Input Signal Indication
Status Indication
Insulation Method
Dielectric Strength
Insulation Resistance
External Power Supply
Derating Conditions
Internal Current Consumption
Hot Swapping
(Removal/insertion under power)
Maximum Heating Value
Approximate Mass
External Dimensions
Specifications
100- to 120-VAC 16-point Input Module
AC100IN-16P
JAMSC-120DAI54309 (EN standard)
100 to 120 VAC
132 VAC
50/60 Hz
47 to 63 Hz
160 mA
7 mA (at 100 VAC, 50 Hz)
14.3 kΩ (at 100 VAC, 50 Hz)
12.5 kΩ (at 100 VAC, 60 Hz)
ON voltage range: 74 to 132 VAC
OFF voltage range: 30 VAC max.
AC type 2 (according to IEC 1131-2)
OFF to ON: 20 ms max.
ON to OFF: 35 ms max.
2
8 points/common
Connect power supplies of the same phases to the common 1 and
common 2.
Removable terminal block with M3 screw terminals.
16
Indicator for each point; lit when the input is ON.
Status saved in internal logic
ACTIVE: Lit during input processing
Photocoupler
1,500 VAC for 1 min. or 1,800 VAC for 1 s between input terminals
and internal circuits and between all input commons
100 MΩ min. at room temperature and humidity between input ter-
minals and ground (measure by a 500-VDC test voltage megohm-
meter)
100 to 120 VAC supplied to signals
None
90 mA max. at 5 VDC (with all points ON)
Permitted
2.0 W
250 g
40.3×130×103.9 mm (W×H×D)
8-7
8.1 EN Standard Compliant I/O Modules
8
Advertisement
Table of Contents
