YASKAWA MEMOCON GL120 User Manual page 247

6 Installation and Wiring
6.2.3 Wiring DC I/O Modules
2) Power Supply Cables and I/O Signal Cables for DC I/O Modules with
CAUTION
12/24-VDC 16-point
Input Module
12/24-VDC 8-point
Output Module
12/24-VDC 16-point
Output Module (sinking)
12/24-VDC 16-point
Output Module (sourcing)
Relay Contact 16-point
Output Module
(DC loads)
3) Power Supply Cables and I/O Signal Cable for DC 32-point I/O Mod-
Terminal Blocks
Do not allow foreign matter such as cable chips in the Modules or Mounting Bases.
Foreign matter in the Modules or Mounting Bases may cause fire, failures and/
or malfunctions.
a) There are five DC I/O Modules with terminal blocks for external connections. See
Table 6.7.
b) To connect these DC I/O Modules, use power supply cable and I/O signal cable of
the size listed in Table 6.7. The cables differ in their permissible current capacity
depending on the conditions of use, such as the ambient operating temperature, so
check the conditions of use and select a cable of appropriate size.
Name Model No.
JAMSC-120DDI34300
JAMSC-120DDO33000
JAMSC-120DDO34310
JAMSC-120DDO34320
JAMSC-120DRA84300
c) M3 Phillips screws are used in the external connection terminals. Accordingly, crimp
terminals for M3 Phillips screws may be used for terminals on the I/O Module end of
power supply cable and I/O signal cable.
d) When using an insulation transformer, always make sure to separate the primary
and the secondary coils. When using a noise filter, also be sure to separate the pri-
mary and the secondary coils.
ule
a) There are two 32-point DC I/O Modules with connectors for external connections.
• 12/24-VDC 32-point Input Module: Model No. JAMSC-120DDI35400
• 12/24-VDC 32-point Output Module: Model No. JAMSC-120DDO35410
b) To connect to these I/O Modules, use of the following I/O signal cables.
• I/O Module cables assembled by the user.
• Yaskawa W0300 32-point I/O Module Cables
• Yaskawa W0302 32-point I/O Module Cables
• Yaskawa W0301 32-point I/O Module Cables
Table 6.7 I/O Signal Cable Size
2
0.2mm
DC loads: 0.2mm
6-20
I/O Signal Cable Size
2
(AWG24) to 0.8mm (AWG18)
2
(AWG24) to 0.8mm
2
(AWG18)