Table of Contents
Advertisement
8) Setting the Timeout Output Data (Only for Digital Output Modules)
Make sure that the Parameter Setting Screen (I/O Map Module Editor) is being dis-
played.
(1) Move the cursor to the input field for SET VALUE and input a value. Then,
press the Enter Key.
Input 100
for example
The MEMOSOFT is set by default to 0.
The timeout output data setting is only for Digital Output Modules and not for Digital
INFO
Input Modules.
9) This completes the I/O allocations.
Press the F9 (Quit) Key to end the procedure.
Fig. 3.35 Parameter Setting Screen: Timeout Output Data
Fig. 3.36 Timeout Output Data Setting
3-117
3.5 Operations Using MEMOSOFT
3
Advertisement
Table of Contents
