Table of Contents
Advertisement
8 EN Standard Low voltage Directive Compliant I/O Modules
8.1.4 Specifications of the I/O Modules
4) 100- to 120-VAC or 200- to 240-VAC 8-point Output Modules
Table 8.5 Specifications of 100- to 120-VAC or 200- to 240-VAC 8-point Output Modules
Name
Model Name
Model No.
Rated Voltage
Allowable Voltage Range
Rated Frequency
Allowable Frequency Range
Maximum Load Current
Output Voltage Drop
Output Delay Times
OFF Leakage Current
Minimum Load Current
Output Type
Number of Commons
Output Power Supply per Common
External Connections
Output Protection Type
Built-in Fuse
Surge Suppressor
Other Output Protections
Number of Outputs
Output Signal Indication
Status Indication
Insulation Method
Dielectric Strength
Insulation Resistance
External Power Supply
Derating Conditions
Internal Current Consumption
Hot Swapping
(Removal/insertion under power)
Maximum Heating Value
Approximate Mass
External Dimensions
Item
100- to 120-VAC or 200- to 240-VAC 8-point Output Module
ACOUT-8P
JAMSC-120DAO83009 (EN standard)
100 to 120 VAC or 200 to 240 VAC
80 to 264 VAC
50/60 Hz
47 to 63 Hz
1.0 A rms/point
1.0 V rms
OFF to ON: 5ms max.
ON to OFF: 1/2 cycle + 5 ms max.
3 mA max. at 240 VAC, 50 Hz
10 mA rms
Triac outputs
8 (Each output circuit is independent.)
Different phase power supplies can be connected to the commons.
Removable terminal block with M3 screw terminals.
Unprotected outputs (according to IEC 1131-2)
None
Varistor
None
8
Indicator for each point; lit when the output is ON.
Status saved in internal logic
ACTIVE: Lit during output processing
Phototriac
1,500 VAC for 1 min. or 1,800 VAC for 1 s between output terminals
and internal circuits and between all output circuits.
100 MΩ min. at room temperature and humidity between output ter-
minals and ground (measure by a 500-VDC test voltage megohm-
meter)
100 to 120 VAC or 200 to 240 VAC to drive loads
None
150 mA max. at 5 VDC (with all points ON)
Permitted
9.0W
300g
40.3×130×103.9 mm (W×H×D)
Specifications
8-10
Advertisement
Table of Contents
