Table of Contents
Advertisement
Whole-home/Phantom Button Programming
Assigning Lighting Zone Controls to Phantom Buttons
Note: If the Chronos
System Bridge is not configured to bridge systems or to use RS-232, Phantom Buttons
TM
are not available and this procedure does not apply.
Step 1
Go to Assign Zones
If bridging two systems:
Main Menu
Whole-home Button Setup
Phantom Button Setup
Assign Zones
If not bridging two systems:
Main Menu
Phantom Button Setup
Assign Zones
Step 2
Assign Zones
Select Button to Assign
1. RM - Home
2. RM - Btn 2
3. RM - Btn 3
4. RM - Btn 4
Exit
Use
and
to highlight a Phantom Button. Press
"Select" (
button) to enter Assignment Mode for
the highlighted button. The following screen will be
displayed when Assignment Mode is initiated:
Assign Zones
Entering Assignment
Mode...
Once Assignment Mode has been initiated, the follow-
ing screen will be displayed:
Assign Zones
Turn on devices to be
assigned to Home.
Copy Button
Note: To use the Copy Button Feature, refer to pages
49-51.
42
Setup Guide for the RadioRA Chronos System Bridge
Select
Continue
Step 3
Assign Lighting Zone
Controls to the Phantom
Button
Assign Dimmers or Switches to the Phantom
Button by turning the Controls ON. Assign all
Dimmers and Switches to be affected by this
button. For SCENE Buttons, include Dimmers
and Switches which are to be turned OFF by
the button.
Assign a GRAFIK Eye
Unit to the Phantom Button by pressing one of
the GRAFIK Eye/GRAFIK RA Control Unit
scene buttons. Assign all GRAFIK
Eye/GRAFIK RA Control Units to be affected
by this button. For SCENE Buttons, include
GRAFIK Eye/GRAFIK RA Control Units which
are to be turned OFF by the button.
Dimmer
Notes:
• GRAFIK Eye/GRAFIK RA Control Units will automati-
cally turn on to Scene 1 once assigned.
• If the wrong Lighting Zone Control is assigned to a
Phantom Button, turn the Lighting Zone Control OFF
to unassign it.
/GRAFIK RA
Control
®
TM
Switch
OR
GRAFIK Eye
Control Unit
TRON
Advertisement
Table of Contents
