Table of Contents
Advertisement
Local Button Programming
Step 5
Program additional buttons
Perform Steps 2-4 (whichever apply) for any
additional buttons to be programmed.
• To copy the button programming from one
Master Control to another Master Control, see
Copying Local Button Programming on page 36.
• Proceed to Step 6 when all buttons on this
Master Control have been programmed.
Step 6
Complete setting light
levels/selecting GRAFIK Eye
and GRAFIK RA
Simultaneously press and hold the 1st and 5th
buttons in the right most column until all LEDs
begin to flutter (approximately 3 seconds).
• Repeat Steps 1 through 6 to set the light
levels/select GRAFIK Eye and GRAFIK RA
scenes on any remaining Master Controls.
• Proceed to Programming the ALL ON and ALL
OFF Buttons on page 34.
Setup Guide for the RadioRA Chronos System Bridge
®
scenes
®
33
Advertisement
Table of Contents
