Table of Contents
Advertisement
Returning Components to Default Factory Settings
Chronos
System Bridge
TM
Returning a Chronos System Bridge to Default Factory Settings will permanently delete all current pro-
gramming information. If the Chronos System Bridge is the main repeater in one system, or bridging two
systems, return all other devices to Default Factory Settings before returning the Chronos System Bridge
to Default Factory Settings. DO NOT do this step unless you are absolutely sure it is necessary. For
more information call the Lutron Technical Support Center.
Step 1
Begin Returning to Default
Factory Settings
Ensure that the ACTIVATE REPEATER LED
or ACTIVATE CONTROLS LED on any
Repeater is NOT ON before proceeding. If
either LED is ON, press the corresponding
button until it's LED turns OFF (approximately
3 seconds).
Press and hold
the buttons for approximately 4 seconds.
Are you sure?
Return to default
factory settings?
Cancel
Do not release the buttons. The following
screen will appear:
Are you sure?
Return to default
factory settings?
Cancel
102
Setup Guide for the RadioRA Chronos System Bridge
and
. Continue to hold
Yes
Yes
Step 2
Complete Returning to Default
Factory Settings
To cancel the operation, simply release
and/or
or press "Cancel" (
To complete the process of returning the
Chronos System Bridge to Default Factory
Settings, continue to hold
press "Yes" (
button).
Are you sure?
Return to default
factory settings?
Cancel
The Chronos System Bridge will reset and
return to the Chronos Configuration screen.
Chronos Configuration
Main Repeater
Bridge Systems
RS-232 Interface
Back
button).
and
, and then
Yes
No
No
No
Done
Advertisement
Table of Contents
