Table of Contents
Advertisement
Returning Components to Default Factory Settings
Repeaters
Returning a Main Repeater to Default Factory Settings will permanently delete all current programming
information. Do not do this unless you are sure that it is necessary. Return all other devices in your
system to Default Factory Settings before returning your Main Repeater to Default Factory Settings. For
more information call the Lutron Technical Support Center.
Step 1
Begin returning to Default
Factory Settings
Ensure that the Chronos
in Activate Controls Mode, or the ACTIVATE
REPEATER LED or ACTIVATE CONTROLS
LED on any Repeater is NOT ON before pro-
ceeding. If either LED is ON, press the corre-
sponding button until it's LED turns OFF
(approximately 3 seconds).
Press and hold (do not release) the BEEP
button. The green BEEP LED will turn ON
after approximately 3 seconds.
98
Setup Guide for the RadioRA Chronos System Bridge
System Bridge is not
TM
Step 2
Complete returning to Default
Factory Settings
While holding the BEEP button, press and hold
the ACTIVATE REPEATER button until the
ACTIVATE REPEATER LED flashes alternately
green and orange.
Release both buttons. All LEDs will flash once
and only the AUXILIARY LED will stay ON,
indicating that the Repeater has been returned
to Default Factory Settings.
Advertisement
Table of Contents
