Table of Contents
Advertisement
Astronomical Time Clock Programming
Step 5
Select Scene to Activate
Select Scene to Activate
1. Morning
2. Scene 2
3. Scene 3
4. Scene 4
Previous
Use
and
to highlight a scene to activate. Press
"Next" (
button) to accept the selection.
Step 6
Set Event Action
Event Action
Scene ON
Action - - - - - - - - - - - - -
Event Type - - - - - - -
Fade Time - - - - - - -
Switches - - - - - - - -
Previous
The Event Action settings determine what happens
when the event is activated.
Action determines whether the scene is turned ON or
OFF.
Event Type determines whether the event activates
the selected scene based on the Time Clock Mode.
• Normal - The event will activate in both
Home and Away modes.
• Home Only - The event will activate only
when the mode is Home.
• Away Only - The event will activate only
when the mode is Away.
Note: The activation time for an Away event will vary
in order to make the residence appear lived-in. The
Away event will activate within 20 minutes (+/-) of the
scheduled time.
Fade Time determines the fade time of the selected
scene. The options are Default (1 second ON, 3 sec-
onds OFF), 1 second, 3 seconds, 10 seconds, 30 sec-
onds, 1 minute, 4 minutes, and Legacy.
62
Setup Guide for the RadioRA Chronos System Bridge
Next
Normal
Default
FO/FO
Finish
If the system contains Dimmers that were manufac-
tured prior to January 1, 2001, the Legacy setting
MUST be used.
Switches determines whether any switches in the
selected scene operate:
• First On / First Off (FO/FO)
• First On / Last Off (FO/LO).
• Last On / First Off (LO/FO)
• Last On / Last Off (LO/LO).
Repeat Steps 1-6 to create additional Time Clock
Events.
Press "Finish" (
button) to accept the changes.
• Time Clock Event Programming is now complete.
Advertisement
Table of Contents
