Table of Contents
Advertisement
Activating the System
Step 4
Activate a Lighting Zone
Control
Go to any Dimmer, Switch or GRAFIK
Eye
/GRAFIK RA
®
TM
Dimmer or Switch ON or OFF by pressing the
tapswitch. On a GRAFIK Eye/GRAFIK RA
Control Unit, change the selected scene by
pressing a scene button.
Dimmer
The light(s) that the Lighting Zone Control
operates will turn ON and OFF a few times
when it has been activated.
If a Lighting Zone Control fails to respond as
?
described above, consult the Troubleshooting
.
Guide
• Repeat Step 4 to activate any remaining
Lighting Zone Controls.
Activate one Lighting Zone Control at a time.
Wait for the control to flash its light(s) before
activating any remaining controls.
• Proceed to Step 5 when all Lighting Zone
Controls have been activated.
Note: When a Lighting Zone Control is prop-
erly activated, the Zone Controls count on the
Chronos System Bridge screen will increment
by one.
Control Unit. Turn the
Switch
OR
GRAFIK
Eye/GRAFIK RA
Control Unit
TRON
Setup Guide for the RadioRA Chronos System Bridge
Step 5
Complete Control Activation
Press "Done" (
System Bridge OR press and hold the ACTI-
VATE CONTROLS button on any auxiliary
Repeater until the green ACTIVATE CON-
TROLS LED turns off (approximately 3 sec-
onds). The green ACTIVATE CONTROLS
LED on ALL auxiliary repeaters will turn off.
The AUXILIARY LED will remain on.
Step 6
Verify that all Controls have
been activated
From System Setup, select Diagnostics.
Diagnostics - System 1
Flash Mode - - - - - - - -
Beep Mode - - - - - - - - -
Global Beep Mode - - - -
Back
Use
or
to activate Flash Mode.
Master Controls, if activated, will flash all
their LEDs. Make note of any Master Controls
that are not activated.
Tabletop Master
button) on the Chronos
No
No
No
Help
Wall Master
23
Advertisement
Table of Contents
