Table of Contents
Advertisement
Initial Chronos
Setting the Initial Chronos System Bridge Configuration
Step 1
Go to the Chronos System
Bridge Configuration Menu
The Chronos System Bridge will display the Chronos
Configuration screen when powered for the first
time or whenever the unit is returned to factory
defaults. This screen is also accessible via the Main
Menu.
Chronos Configuration
Main Repeater - - - - - - -
Bridge Systems - - - - - -
RS-232 Interface - - - - -
Help
Use
and
to change the value of the selected
setting. Use
and
to move to the next / previous
setting.
Step 2
Configure the Chronos
System Bridge
Modify the settings based on how the Chronos
System Bridge will be used in the system. The set-
tings are as follows:
Main Repeater
Set this value to "Yes" if the Chronos System
Bridge will be the Main System Repeater. This
setting can only be changed later by returning the
Chronos System Bridge to factory defaults. Note: In
order to bridge systems, Main Repeater must be
set to "Yes". The Chronos System Bridge will
automatically set Main Repeater to "Yes" when
Bridge Systems is set to "Yes".
Bridge Systems
Set this value to "Yes" if the Chronos System
Bridge will be used to bridge two RadioRA
tems. Otherwise, leave this value "No". This setting
can be changed from "No" to "Yes" later, if desired;
however, this setting can only be changed from
"Yes" to "No" by returning the Chronos System
Bridge to factory defaults.
18
Setup Guide for the RadioRA Chronos System Bridge
System Bridge Configuration
TM
No
No
No
Done
sys-
®
RS-232 Interface
Set this value to "Yes" if the RS-232 interface will
be used for communication to other systems. This
setting can be changed later, if desired.
Note: The Time Clock is always active. To use the
Chronos System Bridge as a Time Clock only, leave
all configurations at "No" and go to Step 3b.
Step 3a
Accept the Chronos System
Bridge Configuration
Once the desired settings have been selected, press
"Done" (
button).
If the Chronos System Bridge is configured as the
Main Repeater, it will then initialize by acquiring
house addresses and master control addresses.
Initializing System
Acquiring House Code - Pass
Acquiring Addresses - - Wait
Initializing System
System Initialized
successfully. Press
OK to continue.
Advertisement
Table of Contents
