Table of Contents
Advertisement
Using the Button Copy Feature
Copying Programming from Master Controls to the
Chronos
System Bridge
TM
The Button Copy feature can be used to copy programming from a Master Control button to a Button / Scene on
the Chronos System Bridge. When using the Chronos System Bridge to bridge two systems, Button Copy can be
used to merge programming from one Master Control button in each system onto one Button / Scene on the
Chronos System Bridge. Note: ROOM Buttons may only be copied to ROOM Buttons, and SCENE Buttons may
only be copied to SCENE Buttons.
Step 1
Go to Assign Zones or Set
Zone Levels
Phantom Buttons:
If bridging two systems:
Main Menu
Whole-home Button Setup
Phantom Button Setup
Assign Zones or Set Zone Levels
If not bridging two systems:
Main Menu
Phantom Button Setup
Assign Zones or Set Zone Levels
Time Clock Scenes:
Main Menu
Time Clock Setup
Manage Scenes
Assign Zones or Set Zone Levels
Contact Closure Input (CCI) Scenes:
Main Menu
Contact Closure Setup
CCI 1 or CCI 2 or Security Setup
Assign Zones or Set Zone Levels (CCI 1,
CCI 2) or Full Zone Assign / Flash Zone
Assign (Security)
Step 2
Select button or scene to
copy to
Use
and
to highlight the button or scene to be
copied to. Press "Select" (
Assignment Mode or Level Set Mode for the
button/scene selected.
Assign Zones
Turn on devices to be
assigned to Morning.
Copy Button
50
Setup Guide for the RadioRA Chronos System Bridge
button) to enter Zone
Continue
Step 3
Select the type of button or
scene to copy from
From the Assign Zones or Set Zone Levels screen
for the selected button or scene, press "Copy
Button" (
button).
Copy From
Phantom Buttons
Time Clock Scenes
CCI Scenes
Master Control
Back
Use
and
to highlight Master Control.
To exit without making changes, press "Back"
(
button). To proceed to the next step, press
"Select" (
button).
Step 4
Select the Master Control
button to copy from
Select Button to Copy
Press and hold a SCENE
button on a Master
Control in order to copy
over the programming.
Back
All LEDs on Master Controls will be blinking. Press
and hold the Master Contol button to be copied from,
until the LED for that button turns OFF.
Press "Continue" (
button) when the button has
been copied.
Repeat Steps 2-4 for additional buttons to be copied.
Press "Exit" (
button) to exit Assignment Mode /
Level Set Mode.
To merge additional programming from a Master
Control button in the other system (when bridging
only), continue to Step 5.
Select
Help
Advertisement
Table of Contents
