Table of Contents
Advertisement
Advanced Local Programming
Step 3
Select the button to copy
On a previously programmed Master Control,
press and hold the programmed button to
copy until its LED turns off (approximately 3
seconds).
Previously Programmed
Master Control
Previously Programmed
Master Control
• Repeat Steps 2 and 3 for all Master Control but-
tons to copy programming to.
When the LED turns off for a
few seconds and then
resumes flashing, program-
ming has been copied to the
unprogrammed Master
Control button.
Newly programmed
button.
Newly Programmed
Master Control
Setup Guide for the RadioRA Chronos System Bridge
Step 4
Complete Copy Button
Programming
Simultaneously press and hold the 1st and 5th
buttons in the right most column until all LEDs
begin to flutter (approximately 3 seconds).
Newly Programmed
Master Control
• Repeat Steps 1 through 4 to copy button
programming on any remaining unprogrammed
Master Controls.
• Copying Master Control button programming is
complete.
37
Advertisement
Table of Contents
