Table of Contents
Advertisement
Diagnostic Tools
Step 3
Exit FLASH Mode
From the Chronos
System Bridge (as a Main
TM
Repeater only):
From Diagnostics, highlight Flash Mode. Use
set Flash Mode to No.
Diagnostics
Flash Mode - - - - - - - - No
Beep Mode - - - - - - - - - No
System Beep Mode - - - No
Back
From a Repeater:
After checking all Controls, press and hold the
FLASH button on any Repeater until the
green FLASH LED turns OFF (approximately
3 seconds).
Green FLASH LED on that Repeater will
go OFF. MAIN or AUXILIARY LED will stay
ON.
Note: If any device is activated (button
press, turned on or off, etc.) or if a
Cordless Master Control enters Sleep
Mode, Flash Mode will exit.
88
Setup Guide for the RadioRA Chronos System Bridge
to
Help
Advertisement
Table of Contents
