Using System Beep Mode - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Diagnostic Tools

Using System BEEP Mode

System BEEP Mode is used to verify that the Chronos
a particular control. Note: If the Chronos System Bridge is not set up as a Main Repeater, this option will not be
available.
Step 1
Enter System BEEP Mode
Main Menu
System Setup
Diagnostics
Diagnostics
Flash Mode - - - - - - - - No
Beep Mode - - - - - - - - - No
System Beep Mode - - -Yes
Back
Use to highlight System Beep Mode. Use
to set System Beep Mode to Yes.
Step 2
Check a Control
Turn the Lighting Zone Control ON or OFF,
press the ALL ON or ALL OFF button on a
Master Control.
System Bridge and all Repeaters in a system can 'hear'
TM
Help
Setup Guide for the RadioRA Chronos System Bridge
Step 3
Repeater response
The Chronos System Bridge and all
Repeaters that can 'hear' the control will pro-
duce multiple audible beeps immediately after
the button is pressed.
RF Signal
BEEP
Step 4
Exit BEEP Mode
From Diagnostics, highlight System Beep
Mode. Use to set System Beep Mode to
No.
Diagnostics
Flash Mode - - - - - - - - - No
Beep Mode - - - - - - - - - No
System Beep Mode - - - No
Back
RF Signal
BEEP
Help
91