Table of Contents
Advertisement
Diagnostic Tools
Viewing Address Usage and Detecting Missing Devices
The Address Usage screen is a useful tool that shows the total number of Repeater, Lighting Zone Control, and
Master Control addresses allocated in the system. This can be helpful in system setup and in troubleshooting.
Note: If the Chronos
System Bridge is not set up as a Main Repeater, or to bridge systems, this section does
TM
not apply.
Step 1
Go to System Setup
Main Menu
System Setup
Address Usage
Note: If the Chronos System Bridge is configured to
bridge systems, the Main Menu will contain a System
1 Setup and a System 2 Setup. These steps should
be repeated for both systems.
Step 2
Query for Addressed Devices
The Chronos System Bridge can query the system for
devices to see if any addressed devices are missing.
Address Usage
Auxiliary Repeaters - - - 2
Zone Controls - - - - - - - 17
Master Controls - - - - - - 6
Back
From Address Usage, use
Auxiliary Repeaters, Zone Controls, or Master
Controls to query. Press "Query" (
query the system. The Chronos System Bridge will
query the system and display the results.
Querying System 1
Querying for
Master Controls...
Note: "Query" (
button) will only be available
when one or more of the selected device type
have been activated.
84
Setup Guide for the RadioRA Chronos System Bridge
Query
and
to highlight
button) to
System 1 Query Results
Found 5 of 6
Master Controls.
Requery
Continue
If all devices are accounted for, pressing "Continue"
(
button) will return to Address Usage.
If all devices are not accounted for:
Zone Controls and Repeaters
Proceed to Step 3 on the next page.
Master Controls
Missing Master Controls may be attributed to Cordless
Master Controls that are asleep. Pressing
"Continue" (
button) will bring up the following
screen:
Missing Master Controls
1 Master Control in
System 1 is missing.
Wake up any Cordless
Master Controls now.
Requery
Wake up any Cordless Master Controls by pressing
any button on the Control.
After all Cordless Master Controls have been awak-
ened, press "Requery" (
tem again.
If all devices are accounted for, pressing "Continue"
(
button) will return to Address Usage.
If all devices are not accounted for, press "Done"
(
button) to proceed to the next step.
Done
button) to query the sys-
Advertisement
Table of Contents
