Programming The All On And All Off Buttons - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Local Button Programming

Programming the ALL ON and ALL OFF Buttons

ALL ON Buttons always turn ON Dimmers (to 100%), Switches, and GRAFIK Eye
(to Scene 1). ALL OFF Buttons always turn these controls OFF. By default, all Lighting Zone Controls are
assigned to all of the ALL ON and ALL OFF Buttons. To unassign controls from the ALL ON and ALL OFF
Buttons, perform the following steps. For an overview of the Master Control programming process, refer to page
25.
These programming steps only apply to Master
Controls equipped with ALL ON and ALL OFF
buttons.
Step 1
Begin the ALL ON/ALL OFF
button programming
On the Master Control to be programmed,
simultaneously press and hold the 2nd and
4th buttons in the right most column until the
upper right LED begins to flash (approximate-
ly 3 seconds).
Tabletop Master
Upper right LED flashes.
34 Setup Guide for the RadioRA Chronos System Bridge
OR
Wall Master
ALL ON
ALL OFF
/GRAFIK RA
®
Step 2
Select a button
Press the ALL ON or ALL OFF button on the
Master Control to be programmed.
For the ALL ON button, the LEDs in all
columns will simultaneously cycle from bottom
to top.
For the ALL OFF button, the LEDs in all
columns will simultaneously cycle from top to
bottom.
All Lighting Zone Controls will turn on.
Control Units
TM
LEDs cycle UP for LEDs cycle DOWN
ALL ON for ALL OFF