Advanced Local Programming; Copying Local Button Programming - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Advanced Local Programming

Copying Local Button Programming

Local Button programming can be copied from a button on one Master Control to a button on another Master
Control. To copy button programming, perform the following steps.
Note: The buttons may be copied as follows:
• ROOM Buttons may be copied to ROOM Buttons
• SCENE Buttons may be copied to SCENE Buttons
Step 1
Begin Copying Button
Programming
On the Master Control to be programmed,
simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Tabletop Master
Note: To copy to an ALL ON or ALL OFF
button, you must enter Assignment Mode (but-
tons 2 and 4) rather than Level Set Mode
(buttons 1 and 5). Only SCENES may be
copied to an ALL ON or ALL OFF button,
never ROOMS. The ALL ON will still turn
lights on to 100% and the ALL OFF button will
still turn lights off, but by copying, you may
choose which lights are affected. ALL ON and
ALL OFF buttons may also be copied to and
from each other in the same way.
36 Setup Guide for the RadioRA Chronos System Bridge
OR
Wall Master
ALL ON
ALL OFF
Upper right LED blinks.
All LEDs on all other
Master Controls will
flash.
Step 2
Select the button to be
programmed
Press and release the button to be pro-
grammed. Its LED will begin to blink.
Button to be
programmed
Button to be
programmed
LED blinks.