Table of Contents
Advertisement
Returning Components to Default Factory Settings
Switch Closure Interface
Returning a Switch Closure Interface to Default Factory Settings will permanently delete all current pro-
gramming information. Do not do this unless you are sure that it is necessary. For more information
call the Lutron Technical Support Center.
Step 1
Begin returning to Default
Factory Settings
Ensure that the Chronos
in Activate Controls Mode, or the ACTIVATE
REPEATER LED or ACTIVATE CONTROLS
LED on any Repeater is NOT ON before pro-
ceeding. If either LED is ON, press the corre-
sponding button until it's LED turns OFF
(approximately 3 seconds).
Press and hold all three buttons until Input
LEDs 1, 4, and Flash begin to flash (approxi-
mately 3 seconds).
LEDs will flash for only 3 seconds.
System Bridge is not
TM
Setup Guide for the RadioRA Chronos System Bridge
Step 2
Complete returning to Default
Factory Settings
Press and hold the Program and Closure Type
buttons until the Switch Closure Interface
resets (all LEDs will flash).
All LEDs (except the Power LED) will turn
OFF indicating that the Switch Closure
Interface has been returned to Default Factory
Settings.
99
Advertisement
Table of Contents
