Table of Contents
Advertisement
Compatibility Information
Using the Chronos
System Bridge with Older RadioRA
TM
On RadioRA Dimmers, Switches, and GRAFIK Eye
times must be used. Raise/Lower functions from Master Controls and the Level Capture feature are also not supported by
these devices shipped prior to January 1, 2001.
Using the Chronos System Bridge with Older RadioRA Master Controls and Interfaces
The Chronos System Bridge Whole-home scenes will not work with Master Controls shipped prior to January 1, 2001. The
buttons on these Master Controls do not send programming necessary to activate the Chronos System Bridge scenes. Also,
this feature was not supported in RA-RS232 and RA-IR Interfaces shipped prior to September 1, 2001. For this reason,
these older devices cannot be used to activate Whole-home scenes.
Using the RA-SCI Switch Closure Interface
The Switch Closure Interface cannot be used to activate Whole-home scenes. The security mode inputs on the Switch
Closure Interface will not work across systems. If a security system is connected to the RA-SCI security inputs, it should be
moved to the security input on the Chronos System Bridge. Refer to Section 6 for instructions on setting up the Chronos
System Bridge contact closure inputs.
Using the RAMC-MFE-WH Security Mode Inputs
The security mode input on the RAMC-MFE-WH will not work across systems. If a security system is connected to the
RAMC-MFE-WH security input, it should be moved to the security input on the Chronos System Bridge. Refer to Section 6
for instructions on setting up the Chronos System Bridge contact closure inputs.
Using Security mode from a RA-RS232 Interface
Security mode activated from an RA-RS232 Interface will not work across systems. If a third-party system is connected to an
existing RA-RS232 Interface, it should be moved to the RS-232 port on the Chronos System Bridge. Refer to Section 5 for
instructions on setting up the Chronos System Bridge RS-232 port.
Consumer Information
This symbol is intended to alert the user to the presence of important installation and operating instructions.
Danger
This RadioRA
system must not be used to control equipment, other than lighting, which is not visible from every mas-
®
ter or local control location. It also must not be used to control equipment which could create hazardous situations
such as entrapment if operated accidentally. Examples of equipment which must not be controlled by this RadioRA
system include (but are not limited to) motorized gates, garage doors, industrial doors, and microwave ovens, heating
pads, etc. It is the installer's responsibility to ensure that the equipment, other than lighting, being controlled is visible
from every master or local control location and that only suitable equipment is connected to this RadioRA system.
FCC Information
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the seperation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Lutron Electronics Co. could void the user's authority to operate this equipment.
Lighting Zone Controls
®
Interfaces shipped prior to January 1, 2001, the Legacy setting for fade
®
Setup Guide for the RadioRA Chronos System Bridge
3
Advertisement
Table of Contents
