Table of Contents
Advertisement
Returning Components to Default Factory Settings
Switches
Returning a Switch to Default Factory Settings will permanently delete all current programming informa-
tion. Do not do this unless you are sure that it is necessary. For more information call the Lutron
Technical Support Center.
Step 1
Turn FASS
Ensure that the Chronos
in Activate Controls Mode, or the ACTIVATE
REPEATER LED or ACTIVATE CONTROLS
LED on any Repeater is NOT ON before pro-
ceeding. If either LED is ON, press the corre-
sponding button until it's LED turns OFF
(approximately 3 seconds).
Move the Front Accessible Service Switch
(FASS) to the OFF position.
Step 2
Turn FASS switch back ON
Press and hold the paddle switch while turn-
ing the FASS switch ON until the LED begins
to flash. The light the Switch controls will
remain OFF.
If the LED does not flash, continue with
Step 3, then repeat Steps 1-3 again.
96
Setup Guide for the RadioRA Chronos System Bridge
switch OFF
TM
System Bridge is not
TM
Step 3
Return to Default Factory
Settings
Release and then press and hold the paddle
switch for 2 seconds.
The light the Switch controls will turn ON and
OFF a few times indicating that the Switch
was returned to Default Factory Settings.
Advertisement
Table of Contents
