Using The Button Copy Feature; Copying Existing Chronos Programming - Lutron Electronics RadioRA RA-SBT-CHR Setup And Installation Manual

Using the Button Copy Feature

Copying Existing Chronos
Button copy is used to copy all programming from one button to another button. The Button Copy feature is
available from the Assign Zones and Set Zone Levels screens for Phantom Buttons, Time Clock Scenes, and
CCI Scenes.
Note: ROOM Buttons may only be copied to ROOM Buttons, and SCENE Buttons may only be copied to
SCENE Buttons.
Step 1
Go to Assign Zones or Set
Zone Levels
Phantom Buttons:
If bridging two systems:
Main Menu
Whole-home Button Setup
Phantom Button Setup
Assign Zones or Set Zone Levels
If not bridging two systems:
Main Menu
Phantom Button Setup
Assign Zones or Set Zone Levels
Time Clock Scenes:
Main Menu
Time Clock Setup
Manage Scenes
Assign Zones or Set Zone Levels
Contact Closure Input (CCI) Scenes:
Main Menu
Contact Closure Setup
CCI 1 or CCI 2 or Security Setup
Assign Zones or Set Zone Levels (CCI 1,
CCI 2) or Full Zone Assign / Flash Zone
Assign (Security)
Step 2
Select button or scene to
copy to
Use and to highlight the button or scene to be
copied to. Press "Select" (
Assignment Mode or Level Set Mode for the
button/scene selected.
Assign Zones
Turn on devices to be
assigned to Morning.
Copy Button
TM
button) to enter Zone
Continue
Setup Guide for the RadioRA Chronos System Bridge
System Bridge Programming
Step 3
Select the type of button or
scene to copy from
From the Assign Zones or Set Zone Levels screen
for the selected button or scene, press "Copy
Button" ( button).
Copy From
Phantom Buttons
Time Clock Scenes
CCI Scenes
Master Control
Back
Use and to highlight the type of button or scene
to be copied from. Highlight Phantom Buttons, Time
Clock Scenes, or CCI Scenes.
To exit without making changes, press "Back"
( button). To proceed to the next step, press
"Select" ( button).
Step 4
Select the button or scene to
copy from
Select Button to Copy
1. Scene 01
2. Scene 02
3. Scene 03
4. Scene 04
Back
Use and to highlight the button or scene to be
copied from.
To exit without making changes, press "Back"
( button). To copy the programming from the
highlighted item, press "Copy" (
Press "Continue" (
been copied.
Repeat Steps 2-4 for additional buttons to be copied.
Press "Exit" ( button) to exit Assignment Mode /
Level Set Mode.
Select
Copy
button).
button) when the button has
49