Table of Contents
Advertisement
Activating the System
Activate Controls
This procedure needs to be performed only if the Chronos
the Chronos System Bridge is not configured as a Main Repeater, skip this procedure. All controls must be oper-
ating (Dimmers and Switches must be wired to a light) in order to be activated.
Step 1
Go to the System Setup Menu
Main Menu
System Setup
Note: If the Chronos System Bridge is configured to
bridge systems, the Main Menu will contain a
System 1 Setup and a System 2 Setup. These
steps should be repeated for both systems.
Step 2
Put the System in Activate
Controls Mode
From System Setup, select Activate Controls OR
press and hold the ACTIVATE CONTROLS button on
any auxiliary Repeater until the green ACTIVATE
CONTROLS LED turns ON (approximately 3 sec-
onds).
System Setup
Activate Aux Repeaters
Activate Controls
Address Usage
Diagnostics
Back
The number of devices and Master Controls currently
in the system is displayed. These numbers will
update as new Zone Controls and Master Controls
are activated. The green ACTIVATE CONTROLS LED
on ALL auxiliary repeaters will turn ON.
Activate Controls
Begin Activating
Controls in System 1
Zone Controls - - - - - - - -0
Master Controls - - - - - - 0
Help
22
Setup Guide for the RadioRA Chronos System Bridge
Help
Done
System Bridge is configured as a Main Repeater. If
TM
Step 3
Activate a Master Control
Go to any Master Control.
Press any button.
• All LEDs will flutter, then
• Top and bottom row will flash alternately
Tabletop Master
The middle row of LEDs will turn ON when the
Master Control has been activated.
If a Master Control fails to respond as
?
described above, consult the Troubleshooting
Guide.
• Repeat Step 3 to activate any remaining
Master Controls.
Activate one Master Control at a time. Wait for
the middle row of LEDs to turn ON before acti-
vating the next Master Control.
OR
Wall Master
ALL ON
ALL OFF
Advertisement
Table of Contents
