Table of Contents
Advertisement
Diagnostic Tools
Using FLASH Mode
FLASH Mode is used to verify that a Control has been activated correctly. Note: If the Chronos
is not set up as a Main Repeater, this option will not be available on the Chronos System Bridge.
Step 1
Enter FLASH Mode
From the Chronos System Bridge (as a Main
Repeater only):
Main Menu
System Setup
Diagnostics
Diagnostics
Flash Mode - - - - - - - - Yes
Beep Mode - - - - - - - - - No
System Beep Mode - - - No
Back
Use
to highlight Flash Mode. Use
set Flash Mode to Yes.
From a Repeater:
Press and hold the FLASH button on any
Repeater until the green FLASH LED turns
ON (approximately 3 seconds).
Green FLASH LED on all Repeaters will turn
ON.
Help
to
Setup Guide for the RadioRA Chronos System Bridge
Step 2
Check all Controls
Master Controls and Interfaces, if activated,
will flash all their LEDs. Make note of any
Master Controls or Interfaces which are not
activated.
Lighting Zone Controls, if activated, will flash
the light(s) they control. Make note of any
Lighting Zone Controls that are not activated.
System Bridge
TM
87
Advertisement
Table of Contents
